##############################################################################
##############################################################################
###
### Running command:
###
###   /home/biocbuild/bbs-3.17-bioc/R/bin/R CMD INSTALL mammaPrintData
###
##############################################################################
##############################################################################


* installing to library ‘/home/biocbuild/bbs-3.17-bioc/R/site-library’
* installing *source* package ‘mammaPrintData’ ...
** using staged installation
** data
** inst
** help
*** installing help indices
** building package indices
ℹ Using R 4.3.1 (lockfile was generated with R 4.2.3)
Warning message:
This project is configured to use Bioconductor 3.15, which is not compatible with R 4.3.1.
Use 'renv::init(bioconductor = "3.15")' to re-initialize this project with the appropriate Bioconductor release.
 
** installing vignettes
** testing if installed package can be loaded from temporary location
ℹ Using R 4.3.1 (lockfile was generated with R 4.2.3)
Warning message:
This project is configured to use Bioconductor 3.15, which is not compatible with R 4.3.1.
Use 'renv::init(bioconductor = "3.15")' to re-initialize this project with the appropriate Bioconductor release.
 
** testing if installed package can be loaded from final location
ℹ Using R 4.3.1 (lockfile was generated with R 4.2.3)
Warning message:
This project is configured to use Bioconductor 3.15, which is not compatible with R 4.3.1.
Use 'renv::init(bioconductor = "3.15")' to re-initialize this project with the appropriate Bioconductor release.
 
** testing if installed package keeps a record of temporary installation path
* DONE (mammaPrintData)